|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Clutch
On my 250 ec 2000 model my clutch doesnt seem to diengage when the engine isn't running is this normal? It works fine when the engines running but when i pull the clutch in when its in gear to push it it wont push..
|
#2
|
||||
|
||||
pretty normal. there are some mods to fix this. but if it'll kick in gear with clutch pulled in, it's probably not worth changing..
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com |
#3
|
|||
|
|||
Ill try kicking it while its in gear then and see thanks again stainless
Your a fountain of knowledge |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to fix MOST clutch problems + cr250r clutch conversion. | stainlesscycle | Enduro Engine - 2 stroke | 70 | 10-26-2020 04:06 AM |