|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
gas gas ec 300 2015 blowing fuses!
Hi guys, problem started last week.
Bike would start first kick, great. It would run great but as soon as I let off throttle it would die and start great again, not a fueling issue. I put it down to electrics, tore everything apart and fixed it by finding my battery was unplugged (to do with ignition key not getting power when I let off the gas??) Bike ran great. I ride approx 15 minutes, shuts off. Next day I take a look at it turns out it is blowing the fuse above the black (earth?) wire. I changed it and it lasted another 15-20minutes but after that I've been changing it and it wouldn't last more than a couple of minutes at maximum per fuse. I can't seem to find information on what exactly this fuse links to (there are 2). I have looked for split wires but can't find anything. |
#2
|
||||
|
||||
Have you probed to see what sort of voltage is coming out of the regulator?
|
#3
|
|||
|
|||
Newer bikes have a DC powered CDI, so any battery trouble means your bike will not run properly.
__________________
2011 EC250E |
#4
|
|||
|
|||
Fuses
Munch, I had a similar problem that I chased for a year. I disconnected all the un necessary electrics, lights, key etc. problem seemed to go away. I recently re connected everything, problem returned. Turns out when I applied the front brake it shorted out 12 volts to ground and blew the fuse.
Anyway check that out, unplug the brake switches see if it makes a difference.
__________________
John Farrell AMRA 8M 2015 GasGas XC300 race |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
fork seals keep blowing | BillH | Enduro Suspension | 7 | 11-19-2015 07:18 PM |
'05 EC300 Keeps blowing bulbs | siaknijustin | Enduro Electrical & Wiring | 5 | 10-02-2014 07:07 PM |
2013 EC250 blowing voltage regulators | rubber Jonny | Enduro Electrical & Wiring | 20 | 05-28-2014 09:51 AM |
EC-400 FSE - Identifying Fuses | lukemillar | Enduro Electrical & Wiring | 4 | 07-08-2013 03:17 PM |
Fuel Pump Fuse (A8) on GG450 blowing | Crankin04 | Enduro Engine 4 stroke (including EFI & Exhaust) | 5 | 08-30-2010 10:41 AM |