|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
02-13-2009, 01:09 PM
|
|||
|
|||
mapper switch or ???????????
is there some kind of gadget i can put on the gasser, for road work, and off road, so i can change the rev's on the bike so the powerband dont kick in on the road, just to get a smoother engine run, { i have seen them for sale for those orange things CALLED KTM,
|
|
#2
02-13-2009, 03:16 PM
|
||||
|
||||
|
What year bike do you have? The newer bikes come with this switch built in, and I believe some older models just require adding the switch (the CDI is already wired for it).
|
|
#3
02-13-2009, 03:23 PM
|
|||
|
|||
|
Quote:
|
|
#4
02-13-2009, 04:05 PM
|
||||
|
||||
|
Not sure if the 02 CDI's have the hi/lo ignition. I know the 05/06 models have the CDI but no switch, then 07 and newer come with the switch. There's lots of info if you search.
|
|
#5
02-13-2009, 07:34 PM
|
||||
|
||||
|
You would need to put in a new ignition and CDI from a 2006 on bike to get it. The 2005 and older did not have 2 mapped ignitions.
__________________
2002 Gasgas EC250 (gone not forgotten) 2012 Ktm 300xc 2001 Gasgas EC300 Lifes journey is not to arrive safely at the grave in a well preserved body, But rather to skid in sideways totally worn out shouting holy cow what a ride !!!!
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CDI switch on an EC200 | captainslow | Enduro Engine - 2 stroke | 1 | 10-26-2010 12:50 PM |
| Dual Map switch.. | stevehipkiss | Enduro Electrical & Wiring | 3 | 01-28-2010 01:29 PM |
| Seriously contemplating switch. | REVERUP | General Discussions & Announcements | 11 | 11-14-2009 06:35 PM |
| headlight switch | jasont1532 | Enduro Electrical & Wiring | 1 | 03-02-2009 07:20 PM |
| Kill Switch | Dingo | Enduro Electrical & Wiring | 4 | 12-10-2008 04:23 PM |
Linear Mode
