|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
EC/ EC-FSR frame
Is the four stroke and the two stroke frame the same?
found a cheep skidplate for a 400-450 ec but does it fit my 250 ec?
__________________
Henrik Schmidt Faster, Faster!! Until the Thrill of Speed, Overcomes the Fear of Death.. Team YamaGas Racing. http://bricksite.com/teamyamagasracing |
#2
|
||||
|
||||
Hmm.. Seems like nobody knows what frame is on a four stroke gasgas?
If you own a 400-450 gasgas could you please post here, or send me some pictures of the "bottom" of the frame, with or without skidplate.. Thanks in advance.
__________________
Henrik Schmidt Faster, Faster!! Until the Thrill of Speed, Overcomes the Fear of Death.. Team YamaGas Racing. http://bricksite.com/teamyamagasracing |
#3
|
||||
|
||||
On the 450 the skid plate is fastened with three bolts onto threaded clips that are placed on welded mounts on the inside of frame tubes. Does the 250 have these mount points?
I doubt there is a chance of direct fit, however a bit of machinig and fabrication of your own mounts would likely make it fit. on page 68 is included the factory sump protector, there you can get an idea of placement of bolts. http://www.gasgasmotos.es/en/manuals...list1.pdf.html |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2002 frame; same as a 2005 frame, or close enough? | Trooper Sam | Enduro Chassis & Body | 0 | 06-10-2010 09:18 AM |
Sub-frame riv nut. | nick790 | Enduro Chassis & Body | 7 | 04-01-2010 11:43 AM |
Would a 450 fit in a 400 frame? | douglase1983 | Enduro Engine 4 stroke (including EFI & Exhaust) | 2 | 03-16-2009 11:43 AM |