|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
I know it sounds weird. But it's a try that doesn't cost you anything. Probably worth to try...
|
#12
|
|||
|
|||
Did you try it? Any news?
|
#13
|
||||
|
||||
No I haven't a chance yet. I've been laying hardwood flooring and it snowed a ton on Saturday.
__________________
Claude 2019 XC300 2010 Nambotin 300 sold '07 EC300 sold '06 EC300 sold '78 Suzuki RM250C2 '75 Yamaha YZ250B sold |
#14
|
|||
|
|||
Ouch, snow isn't what I like.
We have catastrophic weather in Europe too |
#15
|
|||
|
|||
How about the obvious solution: using a hotter plug that burns soot and oil away?
|
#16
|
||||
|
||||
Quote:
If after changing fuel/oil doesn't solve the issue check the choke jet in the carb is nice and tight. It should be pressed in to the body but if it is loose it may allow extra fuel to bypass.
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#17
|
||||
|
||||
1. Many ideas pointing blame at the fuel, oil, mixture, float height, choke, etc... But what about an electrical issue causing a weak spark?
If you fit a new spark plug into the cap, do you get a nice juicy spark? Using a multimeter check for good continuity on zero volt/earth side, good connection between the engine to frame to zero/earth of ignition coil. 2. What oil are you using to oil your air filter? Make sure you're not putting too much oil on the air filter. I've never had any problems fouling a spark plug... until I recently over did it with the air filter oil! Best of luck, Dave. |
#18
|
||||
|
||||
Well I drained the gas and put in fresh gas from the same station and mixed it with Amsoil Dominator at 50:1. Put a fresh plug BR8EIX in. It started right away but that was expected. Going for a ride tonight and we'll see how it starts up tomorrow morning on a cold start.
__________________
Claude 2019 XC300 2010 Nambotin 300 sold '07 EC300 sold '06 EC300 sold '78 Suzuki RM250C2 '75 Yamaha YZ250B sold |
#19
|
|||
|
|||
I'm vey keen....
|
#20
|
||||
|
||||
Good luck and keep us posted...
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fouling plugs? | TavisB | Enduro Intake/Carburetion - 2 stroke | 9 | 09-12-2012 09:56 AM |
ec300 fouling plugs after jetting | ec300 dave | Enduro Intake/Carburetion - 2 stroke | 14 | 05-25-2010 07:32 AM |
i keep fouling spark plugs??? | tom-s | Enduro Engine - 2 stroke | 7 | 08-28-2009 01:37 AM |
gasser 250 sm spluttering and fouling plugs | gasser250sm | Enduro Engine - 2 stroke | 3 | 12-06-2008 03:24 PM |
Fouling plugs | rupecopp | Enduro Intake/Carburetion - 2 stroke | 3 | 08-11-2007 03:43 PM |