|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
bearing sizes pv ?
could someone tell me the bearing sizes for the powervalve? i'd like to order/pick them up before i tear into mine....
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com |
#2
|
||||
|
||||
It's unlikely they are worn. Usually coated in oil and they only move small amounts slowly. Mine have always been in perfect condition - in direct contrast to chassis bearings!
|
#3
|
||||
|
||||
cool, thanks. i was unsure if they would get notchy with sludge/exhaust gas deposits..
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com |
#4
|
||||
|
||||
Mine seem to contain black oil but no sludge when I strip the motor. So I guess there's plenty of carbon in there but doesn't seem to go sludgy. Guess the oil is being replaced fast enough not to sludge up. It doesn't seem to harm them or make them stick. I guess modern 2 stroke oils are pretty good.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Piston info and jug sizes | stay_upright | Enduro Engine - 2 stroke | 0 | 07-24-2009 11:28 AM |
Main Jet Sizes? | ramcclure200 | Enduro Intake/Carburetion - 2 stroke | 2 | 02-23-2008 05:29 PM |
Front Axle Sizes | Motarded1 | Enduro Chassis & Body | 0 | 11-16-2007 03:27 AM |
New knobby sizes | gasgasman | General Discussions & Announcements | 2 | 11-29-2006 04:10 PM |
Pampera Wheel Sizes | clangstone | Other GasGas Bikes/Quads | 0 | 11-05-2006 04:01 AM |