|
Enduro Product Reviews Feedback & Comments on Products Tested |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
I would be tripping all over the things...
__________________
Rob Granger / Katy, TX EC300 Breaking more things by 8:00AM than most people break all day. |
#12
|
||||
|
||||
I'll have to try that Thanks
__________________
Fred Overstreet 2010 EC250 SixDays 2004 GasGas EC300 -Sold to a good home 2006 GasGas EC250-Sold to a good home 2006 GasGas TXT 280 Pro |
#13
|
||||
|
||||
I dont remember mine feeling rough and I spent a lot of time playing around. They took quite a bit of force to get them to seat in the upper leg too. I actually used the fork and slid it down and bottomed to press them in. I think they're just a tight fit.
|
#14
|
||||
|
||||
Stock anodizing should not be rough, my 45s are because they have been re done inside and out in T3 hardcoat, and I suppose the current density in the bath near that edge area is high.
|
#15
|
|||
|
|||
Quote:
They need to learn design and manufacturing ediquite.....did i spell that right?
__________________
www.synergyseals.com 209-938-9726 Being BOLD is BOLD! However, being confident is certain! Ride with confidence again! Made in the USA |
#16
|
||||
|
||||
Rob,
Any issue using the Seal Doctor tool with your seals? |
#17
|
|||
|
|||
good question as I have his seals on the ktm,, I think I'm going to get one of these seal tools to keep around..
__________________
Steve 16 Beta 350rr 04 KTM 525 sx/exc gone 03 KTM 625 sxc-rehab unit-did its job and now gone 03 GG 250 ec-gone 97 GG 250 ec Gone |
#18
|
|||
|
|||
Just used it on my grandsons KTM SX65;worked like a charm. I've now used it on my 08 Husky WB165, 2010 Husky TC250, 2011 Kaw 450, 2001 Honda CR250, and the little pumpkin. Best cheap tool I've ever purchashed.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Has anyone on here used a seal mate? | KTMAndy | Off Road Racer's Corner | 10 | 04-25-2012 12:15 AM |
Seal sizes | kendunn | Enduro Chassis & Body | 0 | 12-19-2010 09:22 PM |
Seal question | Stoby | Enduro Engine - 2 stroke | 3 | 08-01-2010 09:19 PM |
Final drive seal? | nick790 | Enduro Engine - 2 stroke | 2 | 10-14-2009 03:37 PM |
Crank Seal | kim | Enduro Engine - 2 stroke | 2 | 05-18-2008 09:41 PM |