|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Ec300 r 2012 kickstart hitting front pipe
HI
This might be a daft question but my kickstart has started hitting front pipe when pushing it back over into place and is starting to scratch/wear top of front pipe , Nothing seems bent so wondering what is likely cause of this? Thanks for any help. |
#2
|
|||
|
|||
Need to pull the clutch side case cover off and inspect the kick lever gears. It shouldn't swing forward.
|
#3
|
||||
|
||||
You could pull the kick lever and rotate it back one spline.
__________________
Matt Current: 2009 Yamaha FZ1 Previous: 2001 GasGas TXT280, 2001 GasGas XC250, 2004 KTM 200EXC, 2007 GasGas EC250, 2007 Husqvarna SM610, 2008 Husqvarna WB165 |
#4
|
||||
|
||||
This.
Otherwise if the issue is that its rotating in towards the bike too much check the lower knuckle and see if its been rheemed out a bit with use. |
#5
|
|||
|
|||
Thanks
Think the front pipe has takin a good hit from below and pushed upward as rad was pushed up with pipe touching it and that's why kick start been hitting it . |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2012 xc 250 kickstart and 12 xc 300 e start | CycleBuy | New Bikes | 0 | 01-10-2013 04:43 PM |
ec300 kickstart retaining bolt | krazy | Enduro Engine - 2 stroke | 13 | 09-29-2011 11:27 AM |
Front tyre hitting to pipe!!! | gassi | Enduro Engine - 2 stroke | 8 | 11-03-2009 06:04 AM |
Shock hitting the pipe 09 EC 300 | moto9 | Enduro Suspension | 6 | 07-22-2009 09:47 PM |