|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
04-23-2018, 04:32 AM
|
|||
|
|||
shifting problem
Hello all
saturday first ride after pausing a year due to an injury... Had a little crash trying to drive over a lying tree downsides (bike fell on the right side). About 400 metres afterwards I couldnt change gears anymore. Bike is in third gear I think, I can start it and drive but can't shift down or up. The lever is moving, the cam is turning but nothing happens... Any ideas, what the problem could be? To have a first look, which side of the engine should I open? Do I have to remove the engine from the bike? Thx in advance Rob
__________________
greetings from austria muellersq _______________________ EC 300 2006, marzocchi 45 revalved by muellersq and gasgasrider.org  , smartcarb, pv cover spacer by elvis74 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I bought a 2000 xc and keep finding problem after problem | 675AZ | Enduro Engine - 2 stroke | 12 | 02-15-2013 07:25 PM |
| Problem shifting into 1st gear. | jgas | Enduro Engine - 2 stroke | 9 | 01-31-2013 03:38 PM |
| Shifting issues | koka-nee | Enduro Engine - 2 stroke | 3 | 01-26-2011 09:57 AM |
| Shifting Problems | jyellard | Enduro Engine - 2 stroke | 2 | 05-18-2009 05:05 AM |
| Not shifting while under load???? | zero_chances | Enduro Engine - 2 stroke | 4 | 02-16-2007 07:40 AM |
Threaded Mode