|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Top end rebuild...Piston question
This is probably a dumb question, but I am rebuilding the top end of my EC300 and I forgot to look at which way the piston gets installed before I took the stock one out.
I have a Wossner piston and it has an arrow on the top. Do I point this arrow toward the front wheel or the carburetor? |
#2
|
|||
|
|||
Quote:
|
#3
|
|||
|
|||
thanks much!
|
#4
|
|||
|
|||
Also wossner piston rings have a "w" on them these face up,just incase you didn't know
|
#5
|
|||
|
|||
she is installed and running!
|
#6
|
|||
|
|||
"n".....
|
#7
|
|||
|
|||
damn, almost
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
a,b,c piston question ? | britishgas | Enduro Engine - 2 stroke | 24 | 10-07-2016 08:18 PM |
Gt32 327cc rebuild question (splitting case) | Cisco | Enduro Engine - 2 stroke | 5 | 05-02-2015 06:40 PM |
400 FSE rebuild..will a 450 piston fit with rebore | jason r | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 09-04-2014 02:38 AM |
piston question | rbm33 | Enduro Engine - 2 stroke | 9 | 03-08-2012 10:35 AM |
New or Used 200 Piston question | Algieo | Enduro Engine - 2 stroke | 0 | 11-30-2011 04:00 PM |