Any ideas on 2015 EC250 jetting?

[MOGaser]

I should be picking up a 2015 EC250 sometime soon, and just wanted to get a head start on on getting needles and jets ordered. If they are similar to the 2014's it sounds like feul consumption could be an issue, as I will be racing the bike. I'm not sure if the Keithin set up I ran on my previous orange bike would even be close, but I'd like to hear if it would even be a feasible starting place for the new Gasser, as it looks like a few riders on this forum have tried the NECJ Suzuki needles. This is what the previous set up was:
-NECJ 3rd clip
-40 pilot
-162 main
-1.5 AS
-7slide
Most of the riding will be done between 500-1000ft, and mostly technical singletrack. 45-50 miles per tank at AA pace would be nice if possible.Thanks in advance for any advice!

[Jakobi]

That won't be a bad starting point, but probably will be lean off the bottom.

The 250's usually like a bit more fuel. The 2015 I setup here in Australia ended up with 42 NEDW#2 175 and runs pretty smooth and strong.

[MOGaser]

Right on. Thanks Jakobi! I will post up the ooutcome once I figure out what seems to work best.