#1
|
|||
|
|||
08 250 DE with KLX110/CRF50 foot pegs
I had a spare set of Fastway pegs sitting around that were for an aftermarket KLX / DRZ 110 (CRF50) peg mount. They appeared as if they would fit and sure enough; they fit as well as the stock pegs. I moved them down to the lower postion (6' tall) and the brake pedal side folds up quite a bit more than stock.
I paid $50shipped for them and that included a peg mount too. Probably a little cheaper than retail. No comments on the chain! Last edited by five21racing; 01-28-2009 at 03:27 PM. |
#2
|
||||
|
||||
Post a picture if possible. Thanks.
__________________
Matt Current: 2009 Yamaha FZ1 Previous: 2001 GasGas TXT280, 2001 GasGas XC250, 2004 KTM 200EXC, 2007 GasGas EC250, 2007 Husqvarna SM610, 2008 Husqvarna WB165 |
#3
|
|||
|
|||
I will for you tomorrow. There was one washer in the adjustment bolt and I took that out.
|
#4
|
||||
|
||||
They look like they fit very well. Did you use the GasGas OE bolt & pin or was the klx parts required? In other words, was the shaft diameter any different?
Oh yeah, you need to oil your chain.
__________________
Matt Current: 2009 Yamaha FZ1 Previous: 2001 GasGas TXT280, 2001 GasGas XC250, 2004 KTM 200EXC, 2007 GasGas EC250, 2007 Husqvarna SM610, 2008 Husqvarna WB165 |
#5
|
|||
|
|||
Quote:
You could look on www.planetminis.com ; that's where I found these pegs. There's usually rich so-cal kids selling parts for way cheaper than retail. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
foot peg vibration | MIKEWA | Enduro Chassis & Body | 3 | 03-19-2007 08:42 PM |