|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Ignition Coil Location - 2011 EC 250
Hi all,
Trying to rebuild my project bike back to factory as the previous owner has made a bit of a mess with it, the electrics in particular. The ignition coil when I bought the bike was in a vertical position and only attached with one bolt (see attached photo). Assuming this is incorrect as the top bolt in the photo doesn't connect to the frame, I can't figure out the correct orientation as the tabs on the frame don't line up with the coils mounting points. Does anyone have any photos to show the correct layout of the coil, regulator and horn please? Regards Chris |
#2
|
|||
|
|||
That's a larger coil, probably from a different bike. The stock coil mounts on two frame tabs, one above and one below the coil body. I have photos from above and below.
__________________
2011 EC250E |
#3
|
|||
|
|||
Found a picture of the rectifier. Bolts on the left side of the sub frame.
__________________
2011 EC250E |
#4
|
|||
|
|||
Oh excellent! Thanks for sharing, that definitely explains the issue haha! Even the reg is different from yours, this project is full of surprises! 😂
Chris |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ignition coil question, EC300, m.y. 2009 | Mikeyx | Enduro Electrical & Wiring | 12 | 07-25-2020 12:00 AM |
Ignition coil | Gassedshaun | Enduro Electrical & Wiring | 0 | 12-24-2017 04:35 AM |
2005 (maybe other years) ignition coil | Vinny | Parts | 0 | 09-21-2016 11:58 AM |
Ignition coil | davedunaway | General Discussions & Announcements | 2 | 09-04-2012 12:22 PM |