|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#6
|
|||
|
|||
So replacement bearing arrived and i removed the shock to find that the bearing was ok but the two spacers which the bolt goes through had too much clearance so i need these two spacers replaced .
I removed them using a punch and a small hummer and because of the deformation by the punch the bolt now fits tight , so i packed the bearing with grease and pressed the spacers in and fitted the shock back i had to tap the bolt with a hummer to get it through the shock . I will see if this last until i find the spacers and replace them . |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Sachs top bearing removal | 5valve | Enduro Suspension | 7 | 07-12-2022 03:58 PM |
2018 KYB shock bearing | eralha | Enduro Suspension | 9 | 10-31-2019 04:10 PM |
Lower bearing replacement in Sachs rear shock | Blambo | Other GasGas Bikes/Quads | 1 | 04-02-2018 12:51 PM |
ohlins shock bearing | imsimon | Enduro Suspension | 7 | 12-12-2017 03:55 PM |
rear shock bearing | gassergrant | Enduro Suspension | 0 | 12-13-2014 11:33 AM |