|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
EC300 generator question
Can someone tell - how many volts and amperes makes ec300 generator?
|
#2
|
|||
|
|||
2K3 = 70W maximum
Voltage depends on your regulator (or rectifier if estart), assume about 14V
__________________
2011 EC250E |
#3
|
|||
|
|||
http://www.gasgasrider.org/forum/showthread.php?t=164
here says near 85W, so with 14 wolts it's near 6A, and if 12 wolts - 7A. ok. My fan is 12 wolt 3.8A - will it survive direct install? |
#4
|
|||
|
|||
http://www.gasgasrider.org/forum/sho...4&postcount=13
Direct install on an estart bike can run your battery down. Particularily important in slow bushwacking situations. A kickstart only bike will need the rectifier (as previously recommended).
__________________
2011 EC250E |
#5
|
|||
|
|||
I don't have estart or a battery
Here i asking output characteristics of generator, so i will understand which rectifier i need. |
#6
|
||||
|
||||
I'm not the best with electrical, but shouldn't you get the size of rectifier that the fan draws? It won't matter if it's too big as the fan won't draw any more than it needs to run, right?
__________________
Phil (New bike pending...) |
#7
|
|||
|
|||
Use the rectifier that comes with the fan kit. That's all you need.
__________________
2011 EC250E |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
300 EC generator output. | Barbs | Enduro Electrical & Wiring | 2 | 05-23-2015 10:34 PM |
portable generator/inverter | john r b | Other Stuff... | 8 | 01-26-2014 09:57 PM |
Gas to Propane generator conversion | GMP | Other Stuff... | 5 | 11-11-2012 06:24 PM |
flywheel weights kokusan generator | Caravan Monster | All Other Bikes... | 5 | 06-14-2010 11:21 PM |
Spring Generator | moto9 | Enduro Suspension | 0 | 03-10-2009 01:51 AM |