|
|
#11
12-03-2012, 08:26 AM
|
||||
|
||||
If your importer is as good as ours that would be covered. If not, or for a spare, are you familiar with HTS2000 alloy brazing rods? This would be a very good application and much better than epoxy.
|
|
#12
12-03-2012, 12:36 PM
|
||||
|
||||
|
I will check with the gas gas shop here and see what they reckon and then go to a radiator shop and ask them about the ods.
Thanks Glenn, Mark.
__________________
Xr 250 ( first bike) 98 Rmx 2007 Gas gas 300(swapped for trials bike) 2008 280 Raga replica 2012 Gas gas ec 300 E 
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New battery dramas? | nato | Enduro Electrical & Wiring | 10 | 07-25-2012 03:58 PM |
| Need a radiator | Silver | General Discussions & Announcements | 0 | 08-30-2010 04:48 AM |
| anyone have radiator | baker | General Discussions & Announcements | 0 | 10-02-2009 07:34 AM |
| 06 FSE Radiator Cap | cocker | Enduro Engine 4 stroke (including EFI & Exhaust) | 0 | 11-26-2007 04:57 PM |
Linear Mode
