|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Rekluse adjustable slave cylinder question.
Could air in the slave cylinder cause not having installed gap?
I've checked the clutch pack 7 friction 8 steel and the thinner 1mm steel first. Other steel are 1.5 mm I've never had a good clutch over ride last week I took off the slave cylinder and turned out the little allen adjuster to far and a small drop of oil came out. During last weekends ride the clutch got worse. Did not disengage when idle I had to use the clutch lever to get some disengagement. With the clutch lever pulled it felt like it should be without the lever pulled. Could this be cause because of air in the slave cylinder? I check everything else this evening and it is all as should be. The recluse was installed by a shop who never started the bike. (They probably started work to late and I had to pickup the bike for a race) I did find air bubbles in the master the first race weekend when I pulled the lever with the cap off. Will try bleeding the clutch slave and master according the recluse instructions as I'm out of other ideas and this is the job that I was looking least forward too. |
#2
|
|||
|
|||
Quote:
https://youtu.be/xRa_R4AbVQI?t=183 |
#3
|
|||
|
|||
After bleeding the clutch slave I was able to set the installed gap correctly that was a big relieve and one less thing to worry about. Bleeding the master cylinder was a major plain, only back bleeding seemed to work for the master.
At least now I know the whole system inside out |
Tags |
bleeding, rekluse |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
clutch slave cylinder hydraulic seal | Boodog | Enduro Engine - 2 stroke | 3 | 07-08-2013 05:45 PM |
Rekluse Adjustable Slave Cylinder | Fred1956 | Enduro Product Reviews | 16 | 03-27-2013 09:54 AM |
Rekluse adjustable slave cylinder | Fred1956 | Enduro Product Announcements | 0 | 11-28-2012 08:50 PM |
Clutch Slave Cylinder Rebuild | newgaser | Enduro Engine - 2 stroke | 5 | 03-17-2012 08:30 AM |
slave cylinder | new gas gas | Enduro Engine - 2 stroke | 0 | 11-14-2008 04:47 PM |