|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
rekluse adjustment
hi all.......just installed rekluse and experienced some slippage.....put in the tall spring and 40 thou gap but clutch was slipping...adjusted gap to 30 thou and changed to small spring and 1 washer...this is the lowest setting for engagement but am still getting slip...if i bring revs on slowly it flares...if i snap it its ok...has anyone gone to 10 tungsten balls?(i currently use 5) and is this a 2st thing as i never had this problem with 4strokes..thanks..russ
__________________
c'mon ...... you can do it 07 300 |
#2
|
|||
|
|||
You are going in the right direction. However, for best performance, go with the 10 Tungsten Carbide balls. It firms up the low RPM engage.
The best oil to run with the Rekluse is Rotella 15W-40. Even with all this, low RPM engagement under heavy load (starting on a hill) can result in some heavy slip and squeal. Using the clutch lever override to bring up the RPMs will help reduce the squeal.
__________________
Eric K '06 GasGas EC300 '01 GasGas XC300 |
#3
|
|||
|
|||
__________________
--------------------------- GG EC300 2007. |
#4
|
||||
|
||||
balls
yes JD.... a rose by any other name will smell as sweet
thanks erik wll try 10 balls on w'end
__________________
c'mon ...... you can do it 07 300 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
VALVE adjustment | west aussie gas 450 | Enduro Engine 4 stroke (including EFI & Exhaust) | 22 | 03-25-2013 02:50 PM |
Valve adjustment??? | dukbil | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 02-26-2013 11:35 PM |
Clutch adjustment? | Arkangel | Enduro Engine - 2 stroke | 26 | 04-08-2009 09:37 AM |
Clutch Adjustment | anathema | Enduro Engine 4 stroke (including EFI & Exhaust) | 8 | 03-12-2008 10:13 PM |
Rebound adjustment on 04 & 05 MC and EC | FFRDave | Enduro Suspension | 4 | 01-23-2008 10:25 AM |