|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Reed Installation
When re-mounting the reed block is there any sealant I should use? Should I do a leak down test after?
Thanks. |
#2
|
||||
|
||||
Reed install
Are you using the gaskets? there should be two gaskets. if you dont have the gaskets then I would use sealant. But next time removing the reeds will be more
of a clean up. |
#3
|
|||
|
|||
I have the gaskets.
|
#4
|
||||
|
||||
Reed install
I would just use the gaskets only.no sealant.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rear Wheel Bearings - Installation Tip | MattR | Enduro Chassis & Body | 34 | 10-26-2017 02:31 PM |
Trailtech Installation and other mods | Moto7man | General Discussions & Announcements | 10 | 09-06-2012 08:52 PM |
Front Axle Installation Process | mlyle11 | Enduro Suspension | 2 | 05-20-2012 07:55 PM |
Swingarm installation order? | Trailrider | Enduro Chassis & Body | 2 | 06-18-2009 11:08 AM |
07 EC300 - steahly flywheel weight installation | g dirt | Enduro Engine - 2 stroke | 3 | 06-15-2008 05:42 PM |