|
|
|||||||
| Trials Engine Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
10-02-2021, 08:01 AM
|
|||
|
|||
Clutch shim?
Hi, i am replacing the clutch plates in my GAS GAS 300 txt, year is between 2010-2014... there is a spacer between the clutch fingers and the needle bearing, my question is which side of the spacer does the shim sit? i took it off between the fingers and the spacer but it doesnt seem right? Was wondering if anybody had a parts diagram? Thanks in advance.
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2018 KYB shim stacks | Gibnut | Enduro Suspension | 18 | 05-18-2018 12:08 PM |
| Sachs shim 7ID & 9ID, where I can buy? | dewenduro | Enduro Suspension | 11 | 08-15-2016 02:34 PM |
| Marzocchi 45 shim advice? | motopsycho87 | Enduro Suspension | 17 | 10-20-2014 12:47 PM |
| Countershaft sprocket shim | 3hunerd | Enduro Engine - 2 stroke | 5 | 03-24-2012 09:29 AM |
| 45mm zoke shim id | Ed Ventura | Enduro Suspension | 1 | 09-22-2008 05:34 AM |
Threaded Mode