|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
11-15-2007, 02:36 PM
|
|||
|
|||
Reed spacer removal.
Is it safe to run an 02 300 without the spacer? I am loking to pep the bike up a bit, just double checking as I remember something about it possibly causing a lean condition. I have the LTR needle with 42/178 clip #2 spot ridden at 500-5000 feet
Paul B 
|
|
#2
11-15-2007, 09:49 PM
|
||||
|
||||
|
It will be fine without the spacer. Biggest hassle may be the airboot taking a set from years of it being installed and being a few mm short. Clamp the carb in the airboot first, use a hair dryer to soften the rubber, pull it into position and tighten the RAD valve clamp.
|
|
#3
11-16-2007, 08:53 AM
|
||||
|
||||
|
Screws may be too long. I had that problem. Do it though, b/c it woke my 250 up quite a bit.
__________________
Blanco Current ride: 2009 WR450 Previously owned: 12 Gas Gas XC300R, 06 WR450, 06 YZ250, 05 Gas Gas EC250, 05 KTM 450EXC, 02 KX250 w/EG310 kit, 03 YZ250F
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Reed Spacer for EC 250 | GG27 | Enduro Engine - 2 stroke | 4 | 03-28-2009 12:59 AM |
| 05 Reed Spacer | dozerash | General Discussions & Announcements | 13 | 02-07-2009 07:49 AM |
| reed spacer | reeve | Enduro Intake/Carburetion - 2 stroke | 5 | 11-28-2008 09:19 AM |
| Reed spacer | clerky clerk | Enduro Engine - 2 stroke | 1 | 09-22-2008 03:31 AM |
| reed spacer? | moff747 | Enduro Intake/Carburetion - 2 stroke | 2 | 02-26-2008 10:26 PM |
Linear Mode
