|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Need help on top end rebuild
Hi all,
Would appreciate some advice on condition of my top end. The last time I had a 2T top end off there was no talk of Nikasil, power valves, etc. I yanked the head to measure squish in preparation for the RB head mod and after seeing condition pulled the cyl. She's been rattling a bit too... I think I'm in need of some piston /cyl work. Both piston and cyl show some scoring and the wrist pin has noticeable wear. I can't detect any end play in the big end bearing. I think it's a Wiseco piston in there now. It looks nothing like the new-in-box Vertex TM250 piston from with the batch of parts that came with the bike. They are both marked 66.33mm. How does one decide if a cylinder needs replating or maybe over-boring? How much wear can be fixed by replating? Any experience with Millenium Technology as a replating service? TIA for any advice. Ross
__________________
Ross '05 MC 250 '91 Husky 610wxe '04 Duc M800 R.I.P '06 Duc S2r 1000 R.I.P '07 Duc S2r 1000 still rubber side down... ---------------------------------------------------------- May be so... May be not so... My Website |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rebuild time?? | W8TSON | Enduro Engine - 2 stroke | 10 | 08-02-2009 02:05 PM |
125 rebuild chronicle | noobi | Enduro Engine - 2 stroke | 9 | 06-25-2009 04:12 AM |
05 rebuild | brains | Enduro Suspension | 2 | 07-22-2008 08:54 AM |
Rebuild | steve | Enduro Engine - 2 stroke | 8 | 01-13-2008 03:06 PM |
Lower End Rebuild | PEB | Enduro Engine - 2 stroke | 1 | 10-06-2006 06:36 PM |