|
|
|||||||
| Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
07-09-2008, 02:44 AM
|
||||
|
||||
What is the needle jet diameter?
I'm trying to compare different needles but how much extra/less fuel they put in depends on the jet needle diameter.
I have narrowed it down to between 2.835 to 2.9mm but need to know what it actually is... cheers!
__________________
'05 Gas Gas 300 '97 Aprilia Pegaso 650 '99 KTM 200 '95 ish XR630 (died many times in Oz) 
|
|
#2
07-09-2008, 07:20 AM
|
||||
|
||||
|
E-mail Ron at RB Designs and I'm sure he knows. He can replace the "non" replaceable factory needle jet when worn so he must know the exact size of this.
http://www.rb-designs.com Skidad
|
|
#3
07-14-2008, 03:27 AM
|
||||
|
||||
|
For anyone's info it's 2.9.
__________________
'05 Gas Gas 300 '97 Aprilia Pegaso 650 '99 KTM 200 '95 ish XR630 (died many times in Oz)
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CCK needle | pevs | Enduro Intake/Carburetion - 2 stroke | 2 | 02-25-2010 02:04 PM |
| Outer diameter of Sachs fork at the triple clamps | Leon_gasgas | Enduro Chassis & Body | 3 | 01-20-2010 06:21 PM |
| What needle is this? | bitoman | Enduro Intake/Carburetion - 2 stroke | 4 | 07-28-2009 04:26 PM |
| wp or zokes diameter at clamps? | Cruiser | Enduro Suspension | 4 | 04-21-2008 06:20 PM |
| Carb Vent Tube Diameter/Size? | Captccb | General Discussions & Announcements | 1 | 11-05-2007 02:36 PM |
Linear Mode
