|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2007 ec250 powervalve question
Hi I just picked up a 2007 ec250, I noticed a rattle when the rpms are coming down. I read about adjusting the powervalve. when I pulled the pipe off the bike I noticed the powervalve was covered in carbon and I'm able to wiggle the valve back and forth in the cylinder, about an 1/8in either way. Is the normal or is there something that can be tightened or replaced, thanks
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2007 EC300 Showa Conversion - Triples Question | ssaulnier | Enduro Suspension | 5 | 01-21-2018 11:01 AM |
2007 to 2011 frame question | CanGasser | Enduro Chassis & Body | 5 | 09-23-2016 04:44 PM |
Powervalve bearings question | SS109 | Enduro Engine - 2 stroke | 10 | 12-07-2014 11:56 PM |
New 2010 EC300 - NOOB Powervalve Vent Question | JP4 | Enduro Engine - 2 stroke | 2 | 11-29-2010 07:48 PM |
2007 owners - side panel question | Shiny | Enduro Chassis & Body | 2 | 10-29-2007 01:26 PM |