Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


Reply
 
Thread Tools Display Modes
  #11  
Old 07-22-2020, 08:17 AM
Down2fix Down2fix is offline
Member
 
Join Date: May 2020
Location: Bethlehem pa
Posts: 16
Default

Quote:
Originally Posted by Motorman_55792 View Post
Been a long time coming, but I finally took the side cover off and found the problem. The pin that the power valve adjuster screw pushes against was only 1/2 way in the shaft. The case must have held it from coming out completely. Now it runs like it should.
I guess it's time to pull my cover and check this as well, I swear every ride it loses more and bottom end. Like something is slowing backing off or losing its adjustment.
Thanks for the update


__________________
2011 ec250 all the scorpion racing goodies, fmf gnarly, lector carb, fully setup for hare scrambles.
Reply With Quote


  #12  
Old 07-22-2020, 11:56 PM
Motorman_55792 Motorman_55792 is offline
Member
 
Join Date: Oct 2017
Location: Northern Minnesota
Posts: 67
Default

Quote:
Originally Posted by Down2fix View Post
I guess it's time to pull my cover and check this as well, I swear every ride it loses more and bottom end. Like something is slowing backing off or losing its adjustment.
Thanks for the update
I just had a long single track test session today. Works so much better and uses about 25% less fuel with no drool out the pipe. I may be a little lean actually it looks like based on the complete lack of drool after 3 hours of riding.
Reply With Quote
Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Power valve viper77765 Enduro Engine - 2 stroke 11 03-11-2019 09:56 AM
Ec 300 power valve Jonisaacson17 Enduro Engine - 2 stroke 11 07-18-2016 09:01 PM
Loss of power - suspect power valve Jonny Halls Enduro Engine - 2 stroke 4 01-22-2013 09:56 AM
power valve nut bonkeye Enduro Engine - 2 stroke 4 10-11-2012 06:40 PM
Checking for proper power valve operation 2003 EC250 SideshowBob Enduro Engine - 2 stroke 4 04-08-2010 01:00 PM




All times are GMT -5. The time now is 08:01 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org