|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
transmission oil on ec250
the oil looks like it has a little water in it,it is slightly milky ,has always gone like this since i had the bike , changed the oil and after a bit it goes this colour
. where can it get contaminated from ?,read somewhere bout non return valves ???? i found 2 rubber tubes off engine both are open ends. one finishes up by rad and other finishes in skid plate. |
#2
|
|||
|
|||
Water can enter through your breather hoses or it can be the coolant. I say you warm the engine, drain thoroughly, change the oil and route both hoses upward. Ride and avoid water crosses for a while to eliminate the possibility that this is the culprit. Water pump gasket(s) are next step IMO.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ec 300 transmission oil | jetfish | Enduro Engine - 2 stroke | 32 | 10-27-2010 05:00 AM |
Noisy transmission 07 fsr 450 | fastisbetter | Enduro Engine 4 stroke (including EFI & Exhaust) | 6 | 04-08-2010 07:20 PM |
No oil in Transmission | RPB111 | Enduro Engine - 2 stroke | 5 | 03-17-2007 08:49 AM |
EC250 '00 transmission in MC250 '05 | Leon_gasgas | Enduro Engine - 2 stroke | 12 | 01-10-2007 03:10 AM |