|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Indicators don't flash
I would like to install only the 2 direction indicators in the front.
I connect all cabels, plugs and also the flash relais. But the bulbs don't flash they only shine permanantly. What can I do ?
__________________
Husqvarna TE 300 |
#2
|
||||
|
||||
The flasher relay is set up for four bulbs. With only two bulbs, there's not enough resistance to make the flasher work.
|
#3
|
|||
|
|||
OK when I simulate the 2 rear indicators with 2 resistance (5W/13V = 0,420A; 13V/0,42A = 31Ohm/5W) with appr. 33Ohm/5W it can work?
__________________
Husqvarna TE 300 Last edited by Klausen; 10-25-2010 at 10:41 AM. |
#4
|
||||
|
||||
Yes, or you can try an LED flasher.
Most people just hook up bulbs and mount them out of sight. |
#5
|
|||
|
|||
OK the flashing works with 33ohm/5W but a little bit to slow
may be try some 22ohm resistance
__________________
Husqvarna TE 300 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
indicators not blinking | wence | Enduro Electrical & Wiring | 0 | 11-15-2008 05:15 AM |
News Flash | PEB | General Discussions & Announcements | 11 | 09-20-2008 08:28 PM |
Flash Floods -The Bike Shed in Elba, MN | barkeater | General Discussions & Announcements | 1 | 08-21-2007 09:39 AM |