|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
Steering head bearing question
My '07 300 needs to have the steering head bearings replaced. I can't get the bottom 1 to come off the steerer tube. is this thing pressed on or something? or do I just pry it off with a screwdriver or something?
Thanks! |
#2
|
||||
|
||||
It's pressed on.
You can apply some heat to the bearing and it will slide off. |
#3
|
||||
|
||||
Thanks, GGMan! & to put on the new 1, it's the same I presume, a little heat to get it on?
|
#4
|
|||
|
|||
throw the race in the freezer to shrink it a bit. Heat the steering stem to expand it a bit. slap a little anti seize on the steering stem. pop the new race in. Some times the old race can be used to bang the new one in place. I really don't know if heating the steering stem where the race goes in expands it that much ... but its good for psychological reasons!!!
|
#5
|
||||
|
||||
Don't cool the bearing to do on the stem. You'll make the ID SMALLER, and harder to get on the stem. That's going the wrong way.
If anything, throw the bottom triple clamp/stem in the freezer. You'll shrink the ID of the stem, and the bearing will go on much easier. |
#6
|
||||
|
||||
Exhaustive discussion here:
http://groups.google.com/group/rec.m...780efea33b7afa The method I finally used requires a press that opens tall enough for your pieces. It is quite civilized and I didn't curse once. Quote:
__________________
Thanks to FLY Racing. |
#7
|
||||
|
||||
Quote:
__________________
2004 GasGas DE250 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Main Bearing question | wrench | Enduro Engine - 2 stroke | 12 | 05-18-2011 09:39 PM |
steering head bearing #'s | Cruiser | Enduro Chassis & Body | 4 | 04-18-2010 08:13 AM |
Steeing bearing question | lineman12345678 | Enduro Chassis & Body | 0 | 03-06-2010 09:14 PM |
steering head bearings | steve | Enduro Chassis & Body | 4 | 01-28-2008 10:13 PM |
Steering Head Bearing Replacement... | tprnottp | Enduro Suspension | 7 | 10-30-2006 08:45 PM |