|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
So today I replaced the leaking float needle with one from a 2014 model it was 18mm long and old one 15mm thought this was odd as same carb maybe mine had One from an as1? But after a bit of bending I got the float hight to 10mm and while I had the carb apart dropped down to a 40 pilot jet readjusted the air screw now 2 turns out. This has seemed to clean up the whole range no more burble at 3/4 throttle. Still a little rich but a lot better and there is more of a kick to it in the lower revs found that it actually sometimes breaks the traction when going up a technical section. Guess the Suzuki needle will make it more liniear and KTM needle more of a kick?
750ft 15c in sunshine mode |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Jetting (needles) 2013 gasgas ec 250 | nickp | Enduro Intake/Carburetion - 2 stroke | 7 | 11-03-2013 02:25 PM |
2012 300 jetting | bones150 | Enduro Intake/Carburetion - 2 stroke | 3 | 05-10-2012 05:56 AM |
2012 300 JD jetting kit | mblazer11 | Enduro Intake/Carburetion - 2 stroke | 11 | 04-17-2012 10:12 PM |
Where to buy needles. Other jetting questions. | IDAHOSPUD | Enduro Intake/Carburetion - 2 stroke | 1 | 11-07-2011 02:08 PM |
JD Jetting Spreadsheet - anyone know codes for JD needles ?? | DaveH | Enduro Intake/Carburetion - 2 stroke | 1 | 02-13-2011 09:40 AM |