|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Anyone have the FMF Q?
Just wondering if anyone is running the new FMF Q muffler. How do you like it and is it significantly less noisy than other fmf mufflers
sam |
#2
|
||||
|
||||
FMF doesn't make one for a GG.
__________________
2005 YZ 250F |
#3
|
|||
|
|||
Really?? It's listed on the go fasters website
|
#4
|
||||
|
||||
All i see on the site is the Power core 2 and turbine core 2 silencers. I have the TC II and it works fine. More free flowing than stock with a fairly modest gain in power.
__________________
2002 Gasgas EC250 (gone not forgotten) 2012 Ktm 300xc 2001 Gasgas EC300 Lifes journey is not to arrive safely at the grave in a well preserved body, But rather to skid in sideways totally worn out shouting holy cow what a ride !!!! |
#5
|
|||
|
|||
Here is where I found the "Q" listed
http://www.gofasters.com/index.php?m...&cPath=101_105 Is the turbine core 2 louder than the stock one? |
#6
|
||||
|
||||
A little louder but not by much. It sounds better but not louder than any other 2 stroke 250. It is about the same as my friends stock RM250.
__________________
2002 Gasgas EC250 (gone not forgotten) 2012 Ktm 300xc 2001 Gasgas EC300 Lifes journey is not to arrive safely at the grave in a well preserved body, But rather to skid in sideways totally worn out shouting holy cow what a ride !!!! |
#7
|
||||
|
||||
Quote:
__________________
2005 YZ 250F |
#8
|
|||
|
|||
I read that a ’99-02 KX FMF Q silencer would fit the GasGas, so I bought one off ebay.
The Q silencer is about as long as the stock GasGas Euro silencer and a few inches longer than the GasGas FMF TC2 silencer. Fitting the silencer on my ’06 EC300 required the following… > Trim ~0.2 inches off the end of the stock GasGas pipe. > Trim ~0.4 inches off the silencer tube where it slides over the pipe. > Slight trim of the rubber sleeve that fits over the pipe joint. > Bend the silencer body up a few degrees relative to the silencer pipe to get the mounts to align. > Bolt into place. The FMF Q tucks in well and provides adequate tire clearance. It fits pretty well except that the highest point on the silencer just touches the rear fender. From the riders perspective, I can’t hear a difference in noise level between the FMF Q, the FMF TC2 and the stock GG Euro silencer with the rest of the engine noise. As a note, the KX FMF Q would not fit on my ’01 XC300 as it had too much interference with the rear fender.
__________________
Eric K '06 GasGas EC300 '01 GasGas XC300 |
|
|