|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#12
10-01-2006, 06:44 AM
|
|||
|
|||
I had an EFM on my bike at one time. The dampers are used. In fact, the early EFM its own clutch basket. What he does now is modify the stock basket with threaded holes in the ends of the basket fingers and the rest of the clutch assembly is stock except for the pressure plate, which is bolted onto the clutch basket at the ends of the fingers.
I replaced the dampeners just before I went back to a standard clutch. The old ones had cracks. In hindsight they were probably okay but sometimes it's better to replace them if in doubt. Jon '01 XC300 Last edited by jlk_250; 10-01-2006 at 06:45 AM. Reason: add my name 
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| might be a dumb question, but im new, so give me a break | dank | Enduro Intake/Carburetion - 2 stroke | 7 | 03-26-2010 08:52 AM |
| my rear break lever is hammered | fullthrottle | Enduro Chassis & Body | 8 | 02-24-2010 11:30 PM |
| Top end break in, heat cycling | rpduc | Enduro Engine - 2 stroke | 9 | 05-04-2009 11:55 AM |
| new ring break in | skid jackson | Enduro Engine - 2 stroke | 3 | 05-18-2008 05:54 PM |
| Top End break-in | gasIdaho | Enduro Engine - 2 stroke | 1 | 06-05-2007 07:54 AM |
Linear Mode
