|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
07/08 air boot and box
Is it just my bike or does the new design let in way to much water and crud into the air boot and box? It seems the air boot is just press fit into the box with out any sealant. Water also enters up toward where the rear fender is attached to the sub frame.
85 enduro miles of wet Washington single track and my air box was full of mud and the motor definitely drank its share of water. It never shut down, but I'm sure it took some hours of its life. A enduro bike sent out of the factory like this, pathetic! As you can tell I'm not very happy with this lack of R and D of this new air box/boot design and the lack of any sealant used to ensure a good seal. If you get a 2007 and up model, pay much attention to this area and seal it up like it should have come from the factory. O.k. I'm done with my rant now and i still do really love my Gas Gas. Roscoe
__________________
Huge thanks: GAS GAS OFFROAD US, Skagit Powersports, Cycle Gear, LTRacing, Scorpion Racing, users of GasGasrider.org, and CFMC! |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Boot damage | jhendr3702 | General Discussions & Announcements | 3 | 11-08-2008 08:35 AM |
Big Boot | Loosenut | Ride Reports | 0 | 06-26-2007 06:14 PM |
Best Place For Boot Repair... | tprnottp | General Discussions & Announcements | 10 | 06-07-2007 12:43 PM |
Boot Resole | MattR | Enduro Product Reviews | 0 | 08-06-2006 09:11 PM |