|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Please help 01 ec250 jetting carb issue
2001 ec250 Took it out today for the first time after rebuilding N1ED needle #2 clip 38 pilot and 175 main bottom was great mid it cut out real bad like it was too lean late in the ride it just died I though it fouled a plug but I put a new plug in it nothing so I tapped on the carb with screw driver and it fired up but cut out really bad I'm guessing the float was stuck closed any help here would be great thanks
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2011 EC300 jetting issue | Rampart | Enduro Intake/Carburetion - 2 stroke | 6 | 04-09-2017 11:41 AM |
98 ec250 carb and jetting | OKFiremanMark | Enduro Intake/Carburetion - 2 stroke | 5 | 07-22-2013 04:00 PM |
Another jetting issue(imagine that) | bowhunter007 | Enduro Intake/Carburetion - 2 stroke | 62 | 11-18-2012 04:54 PM |
2003 ec250 clutch issue | dirt2road | Enduro Engine - 2 stroke | 12 | 08-17-2012 03:15 PM |
jetting - idle issue. | stainlesscycle | Enduro Intake/Carburetion - 2 stroke | 7 | 12-30-2009 02:47 AM |