|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Power Valve Adjustment
In disassembling my EC200 for a complete rebuild i loosened the locking screw on the "centrifugal mechanism lever" - screw 3 in this image:
How do i set it at the correct position? Should there be any play in the lever when set? I found that if i set it without any pretension on the spring that there is about 2-4mm of play in the powervalve! |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
VALVE adjustment | west aussie gas 450 | Enduro Engine 4 stroke (including EFI & Exhaust) | 22 | 03-25-2013 02:50 PM |
Valve adjustment??? | dukbil | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 02-26-2013 11:35 PM |
Power Valve Adjustability | jefgil123 | General Discussions & Announcements | 32 | 01-01-2011 11:12 AM |
Power valve | bens25au | Enduro Engine - 2 stroke | 2 | 02-09-2008 11:02 PM |
Power Valve rebuild | Gas Stu | Enduro Engine - 2 stroke | 2 | 09-19-2007 12:38 AM |