|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Fitting new kill switch, which cables.
I have a 2005 xc300 which I have removed the lights off. All I have done is unplugged the front and back units, and the speedo and the horn, and handle bar switch. There isnt a map switch. I have then taped up the plugs on the bike to protect from damp. I have a 2 wire button kill switch and was wanting to know which cables to connect them to. regards mark
|
#2
|
|||
|
|||
Have a look here. http://www.gasgasrider.org/forum/showthread.php?t=17901
The only difference might be the wiring colors on your older bike.
__________________
2011 EC250E |
#3
|
|||
|
|||
thanks for that, so if I read it right, earth one and connect the other to one of 2 wires depending on the year/colour config of the cables.
|
#4
|
|||
|
|||
Correct, one wire from your CDI (usually black/yellow or yellow/black) gets made to yellow/green (chassis ground) by the kill button to short out the ignition.
__________________
2011 EC250E |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
kill switch??? | spooly | Enduro Electrical & Wiring | 29 | 04-08-2014 01:06 PM |
Kill switch | wheelie | Enduro Electrical & Wiring | 2 | 05-21-2012 07:12 PM |
kill switch | Rabbitist | Enduro Electrical & Wiring | 3 | 05-22-2011 07:07 PM |
Fitting map switch to 200? | blanc | General Discussions & Announcements | 7 | 12-14-2010 07:44 AM |
Kill Switch | Dingo | Enduro Electrical & Wiring | 4 | 12-10-2008 04:23 PM |