|
|
|||||||
| Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
02-16-2016, 01:09 PM
|
|||
|
|||
Setting Float Level
I saw this thread on another forum and it looked very interesting.
http://www.allthingsmoto.com/forums/...ght-way-65541/
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar 
|
|
#2
02-16-2016, 11:09 PM
|
|||
|
|||
|
The thread mentions that there should be a correction for the angle of the carb
So once it is angled where do you set the level to? The middle of the carb or the lowest edge of the meeting faces?
__________________
2003 txt250 Pro 2013 Ossa 280i
|
|
#3
02-17-2016, 12:44 AM
|
||||
|
||||
|
Once you set the float level, make sure you level the carb in the bike. The carb is on two different angles within the bike. I was surprised how far off my eye was compared to putting an actual level on the carb top with the bike on a level stand.
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ASII Float Level With Pix | andoman | Enduro Intake/Carburetion - 2 stroke | 30 | 12-29-2019 12:10 PM |
| How to set float level. Revisited. | gasgasman | Enduro Intake/Carburetion - 2 stroke | 48 | 11-10-2018 05:11 AM |
| float level 05 ec200 | paulos | Enduro Intake/Carburetion - 2 stroke | 3 | 02-18-2014 05:47 PM |
| float level | drn51 | Enduro Intake/Carburetion - 2 stroke | 5 | 01-12-2013 12:15 AM |
| Float Level, please explain? | rod | Enduro Intake/Carburetion - 2 stroke | 13 | 02-12-2011 01:03 PM |
Linear Mode
