|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cylinder and Piston Measurements, EC300
I?m freshening up my 2010 EC300 and got the measurements (attached) using a bore gauge on the cylinder and calipers on the piston. What are some of your opinions on plating vs not plating? There is some ovalization in the bore but is it necessary to replate? Either way I?m getting a new top end kit in there. Thanks!
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Brand new 400 - 450 ??? cylinder and piston | Stoby | Parts | 0 | 06-18-2015 04:46 PM |
Cylinder Plating to Matched Piston ?? | GasGasDreamer | Enduro Engine - 2 stroke | 6 | 01-13-2014 10:10 PM |
EC200 Cylinder Measurements | WTEC | Enduro Engine - 2 stroke | 43 | 09-11-2013 12:14 AM |