|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Thanks for the quick reply Eric,
By "that setup" I assume you mean what's in there now... I'm reasonably happy with the way the thing runs, but I really have NO basis for comparison so I wonder. The fuel consumption is one thing. Others are: - It seems to "sputter" a lot at smaller throttle openings -The "beast" within comes on with a vengeance at times too. That's why I was intrigued by Pobit's comments on the CCK needle. At 55 yrs. I don't need to loop that thing again... - It kills very easily if I get clumsy about braking into corners.
__________________
Ross '05 MC 250 '91 Husky 610wxe '04 Duc M800 R.I.P '06 Duc S2r 1000 R.I.P '07 Duc S2r 1000 still rubber side down... ---------------------------------------------------------- May be so... May be not so... My Website |
#12
|
|||
|
|||
Ross,
I spent a lot of time trying to tune the setup you currently have and was never pleased with it. I had the same issues you have. The set up starting point I was referring to and recommend is #7 slide, 42pilot, CCK#3, 178 for sea level, 60F. (A #8 slide works a bit better on some engines.) With fine tuning, this set up will address the issues you are having. Further, you will get better part throttle controllability and better fuel mileage.
__________________
Eric K '06 GasGas EC300 '01 GasGas XC300 |
#13
|
|||
|
|||
Thanks Eric,
GOOD! I'm glad you weren't referring to my current setup... I'm anxious to see how this beast behaves with the CCK. I'd characterize the power delivery right now as "angry" or "violent." I'm not into angry or violent any more...
__________________
Ross '05 MC 250 '91 Husky 610wxe '04 Duc M800 R.I.P '06 Duc S2r 1000 R.I.P '07 Duc S2r 1000 still rubber side down... ---------------------------------------------------------- May be so... May be not so... My Website |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
VALVE adjustment | west aussie gas 450 | Enduro Engine 4 stroke (including EFI & Exhaust) | 22 | 03-25-2013 02:50 PM |
Help! Flywheel weight doesn't fit with 2k3 on 2003 EC250? | SideshowBob | Enduro Engine - 2 stroke | 12 | 04-28-2010 11:02 PM |
idle speed adjustment | Qui-gon | Enduro Engine 4 stroke (including EFI & Exhaust) | 5 | 04-07-2008 06:07 PM |
It doesn't fit.... | stay_upright | General Discussions & Announcements | 7 | 03-04-2008 12:55 PM |