|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#11
01-28-2012, 06:25 AM
|
|||
|
|||
Yeehaaahhh!! went for a ride today (only short as I live in Suburbia) The Tusk CR250 fibres worked almost perfectly. I had a a very small amount of drag when I had the clutch fully pulled in and reving the engine. This may be due to the fingers on the basket needing touching up with a draw file as they are a bit Notchy or could be that Im using Mobil1 5wt synthetic, Dunno but down a couple of fire trails fully cranked I had no slipping or bad noises at all. By the time I got home the clutch drag was all but gone. The leaking waterpump isue was due to a worn w/Pp bearing so that was easily fixed.
Overall Im a happy camper, thanks for the tips and info parted onto this choice Forum.  Ollie 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TXT 200 pro clutch.. | jhendr3702 | Other GasGas Bikes/Quads | 1 | 01-28-2011 10:10 AM |
| Clutch problems | gaser | Enduro Engine - 2 stroke | 5 | 11-15-2010 07:51 AM |
| Clutch going out? | Crankin04 | Enduro Engine 4 stroke (including EFI & Exhaust) | 5 | 07-30-2010 01:00 PM |
| 450 clutch, same as DRZ? | Devondan | Enduro Engine 4 stroke (including EFI & Exhaust) | 2 | 10-01-2009 07:58 PM |
| What clutch oil is best? | wence | Enduro Engine - 2 stroke | 5 | 08-20-2009 03:57 AM |
Threaded Mode