|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Clutch Spring Torques
Hi there, just a quick question does anyone know the torque setting for the bolts that hold the clutch springs to the basket. I've had a look on the torque settings page but I can't find it, any help would be appreciated.
|
#2
|
||||
|
||||
Lightly seating the bolts is all thats required. The preload from the springs acts like a lock washer preventing the bolt from backing out.
|
#3
|
||||
|
||||
10Nm I believe. Quite light. It's in the engine rebuild manual - downloadable but only listed under one year I think. But the engines haven't really changed much.
In general sense check any torque setting you read in a GG manual. There's a general torque table on this site somewhere but it is a general and I'm sure good for general bolts but probably doesn't apply to any high tensile and or specialist stuff. |
#4
|
||||
|
||||
Quote:
|
#5
|
||||
|
||||
I'll never forget as it was a good laugh when someone called asking that and the guy working for me told em to tighten one till it breaks and the others not as much.
__________________
Dont follow me, You wont make it. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
48 280 spring.. | jhendr3702 | Enduro Suspension | 3 | 06-09-2010 05:11 AM |
Spring help | jriley43 | Enduro Suspension | 0 | 05-21-2009 10:54 AM |
Spring | steve | Enduro Engine - 2 stroke | 2 | 03-03-2008 03:44 PM |
Triple clamp torques ? | Brian VT | Enduro Suspension | 3 | 01-27-2007 06:54 AM |
Spring/Sag ? | skid jackson | Enduro Suspension | 0 | 10-08-2006 09:35 PM |