|
|
|||||||
| Enduro Engine 4 stroke (including EFI & Exhaust) 4 stroke engine, EFI, and exhaust discussion |
|
|
Thread Tools | Display Modes |
|
#1
06-09-2016, 11:05 PM
|
|||
|
|||
Crank case breather/ Oil in intake
Finally got a few issue sorted out on the 450 (2005 FSE) and took it for the first small spin not a power house but its ok. When I got back I noticed oil poured all over the swing arm and the Air filter was soaked I checked the oil and its a bit high Im guessing it may have been over full from the last Oil change, not really sure.
My question is do these bikes have a Crank case breather issue or is it common to relocate the hose out side the intake? Or is this just a non issue on these bikes? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crank Remover and Crank Installer tools for EC250 | Fabry | Enduro Engine - 2 stroke | 5 | 06-25-2013 07:24 PM |
| breather tube | bonkeye | Enduro Engine - 2 stroke | 5 | 03-13-2012 06:09 PM |
| Crank case interchangability | Rabbitist | Enduro Engine - 2 stroke | 5 | 09-21-2011 05:44 AM |
| Crank bearing spinning in case... | CDBiker220 | Enduro Engine - 2 stroke | 8 | 02-16-2011 11:53 AM |
| pv breather | jprh | Enduro Engine - 2 stroke | 5 | 02-21-2009 08:38 PM |
Threaded Mode