#1
|
|||
|
|||
exhust springs and orings
any know if the exhust spring and orings for a 2005 bike are used on anyother bikes so i dont have t buy genuine
|
#2
|
||||
|
||||
Measure the length of the spring you can buy them on flea bay!
http://www.ebay.co.uk/itm/RFX-Pair-o...item3a77ee655a
__________________
2005 EC 200 Last edited by Pepperami; 01-13-2013 at 07:30 AM. |
#3
|
|||
|
|||
good spot just need oring size now as there was non in mine
|
#4
|
||||
|
||||
Silicon! will work.
__________________
2005 EC 200 |
#5
|
||||
|
||||
44x3 from memory. Viton is preffered, but silicone will work.
|
#6
|
||||
|
||||
BunaN (Nitril), Silicone, and Viton will all work. BunaN has inadequate high temp specs and hardens fairly quick, then the leakage starts. Silicone has good temp specs but poor abrasion resistance, and gets eaten up by pipe vibration as fast as the cheap BunaN orings get hard. Never use silicone in a dynamic seal application. Viton is the material of choice, lasts far longer, and is also the most expensive.
44x3 |
#7
|
|||
|
|||
the o rings are about a pound each,so are not worth scrimping on
__________________
GG ec 250 1998 v strom 1000 2008 |
#8
|
|||
|
|||
yeah got sorted in the end was cheep getting gasgas ones
|
#9
|
|||
|
|||
Where do people get their exhaust o rings from? I need a pair and having no luck!
|
#10
|
||||
|
||||
Quote:
http://www.mcmaster.com/
__________________
Thanks to FLY Racing. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
fork bleeder screws and orings | flybars | General Discussions & Announcements | 9 | 09-10-2012 07:28 AM |
Head orings | Brian VT | Enduro Engine - 2 stroke | 5 | 09-05-2008 11:49 AM |