|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
too low compression?
I measured the compression on my gasser ec250 today, and got 125psi with cold engine (WOT). The bike is quite difficult too start and runs really rich, though if the petcock is turned off while the engine is running it runs quite well until it runs out of gas ofcourse.
Below are some pictures i took of the piston through the exhaust port. Time for replacement? |
#2
|
||||
|
||||
You should do the test with a warm engine, and kick until the gauge peaks.
What is your altitude? Hours on motor? Pics look normal, actually good as no blowby is evident. If its rich, look at the float hight and jetting first. |
#3
|
|||
|
|||
Ah yes.. i guess a warm engine would result in higher readings, but I just wanted to check that the piston wasn't completly bust. Altitude is very close to sea level. Not sure how many hours.
I have checked the float height twice and made sure that the floater isn't twisted or damaged in any way. The jetting should be in order, atleast according to the diagram in the service manual. I'm using a 180 main jet, and with the low temperatures here in sweden I should actually be using a larger one. But still it just floods the engine at full throttle. I have also tried setting the needle at it's lowest setting. Replaced air filter, spark plug, HT wire, inspected the killswitch, reed valve, exhaust valve without any improvment. I'm thinking about pushing it into a lake or something soon |
#4
|
|||
|
|||
Has this just started to happened or has been like that for a while ?
What color is the spark plug after a WOT run ? I'm running a 168 main and a 38 pilot at sea level on a 03 300. Kim
__________________
08 TXT 300 06 Gasgas EC200 03 Gasgas EC300 05 Pampera 250 |
#5
|
||||
|
||||
I know it sounds obvious, but last year another guy in Sweden had trouble and turns out he had the restrictor plate still in the airboot. Are you sure the PV is opening completely?
|
#6
|
||||
|
||||
Strange, I'd have thought float height if you hadn't checked.
Is the needle valve ok? The piston looks in great condition as does the PV. Jetting seems to vary a lot on Gassers, from bike to bike, for some reason. Think it's like the old quadratic equations, there's always more than one solution with a Gasser. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
300 compression | stay_upright | Enduro Engine - 2 stroke | 13 | 08-27-2009 05:24 PM |
125 compression | noobi | Enduro Engine - 2 stroke | 17 | 04-17-2009 11:07 PM |
EC200 compression | Bearman | Enduro Engine - 2 stroke | 8 | 02-22-2009 04:03 AM |
160lb compression on my EC 300 | FFRDave | Enduro Engine - 2 stroke | 18 | 02-28-2008 09:40 PM |
Compression low? | Wellsy | Enduro Engine - 2 stroke | 10 | 11-28-2007 07:05 AM |