|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
too low compression?
I measured the compression on my gasser ec250 today, and got 125psi with cold engine (WOT). The bike is quite difficult too start and runs really rich, though if the petcock is turned off while the engine is running it runs quite well until it runs out of gas ofcourse.
Below are some pictures i took of the piston through the exhaust port. Time for replacement? |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
300 compression | stay_upright | Enduro Engine - 2 stroke | 13 | 08-27-2009 05:24 PM |
125 compression | noobi | Enduro Engine - 2 stroke | 17 | 04-17-2009 11:07 PM |
EC200 compression | Bearman | Enduro Engine - 2 stroke | 8 | 02-22-2009 04:03 AM |
160lb compression on my EC 300 | FFRDave | Enduro Engine - 2 stroke | 18 | 02-28-2008 09:40 PM |
Compression low? | Wellsy | Enduro Engine - 2 stroke | 10 | 11-28-2007 07:05 AM |