|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
V-force
V-force 3s does the reed cage go on the motor before the alum. spacer or after?
|
#2
|
||||
|
||||
If you use the spacer, it goes on first to move the reed block out of the cases and increase volume.
|
#3
|
|||
|
|||
Quote:
Glen, I tore this bike down to the bare frame in Dec '07. Some stuff I forgot cause of time I 'm a little vaqe.Except for plastics and 6 bearings in the motor,everythings been replaced or rebuilt.Once I get my counter-shaft seal I CAN HOPFULLY START IT!!!! most off the motor stuff was brand new to me thats why all the stupid questions the last few months. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Force Rad Guards | add | Enduro Product Reviews | 0 | 05-09-2009 05:16 AM |
Boysen and V-force carb boot ? | joey11 | Enduro Intake/Carburetion - 2 stroke | 2 | 10-20-2008 11:40 AM |
Force Radiator Guards | Boomhauer | Enduro Product Reviews | 10 | 03-03-2008 08:01 PM |
V Force 3 Reeds Question | gasIdaho | Enduro Engine - 2 stroke | 11 | 09-02-2007 12:02 PM |