|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
gear changer shaft fitment
my gear changer shaft is rather rusty on the spline end so needs replacing
i have a 2000 EC300 but the replacment i found is from a 2003, are they the same or wont it fit. |
#2
|
|||
|
|||
They are the same in all the Gassers. Just put a new one in my 97'. Pick up a new shaft seal to when you replace it, good insurance.
|
#3
|
|||
|
|||
great thank you
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EC200 Six Days gear shaft broken | Muzungu | Enduro Engine - 2 stroke | 8 | 03-09-2011 08:49 PM |
Bitech tire changer | Kurdt | General Discussions & Announcements | 11 | 06-17-2010 09:12 AM |
Gear shift shaft question (again) | Trailrider | Enduro Engine - 2 stroke | 7 | 04-06-2010 09:54 AM |
Gear Selector Shaft Bent? | iancp5 | Enduro Engine - 2 stroke | 11 | 03-29-2009 04:39 PM |
Gear box mess (circlip fitment) | craigyboy | Enduro Engine - 2 stroke | 2 | 10-28-2008 10:11 AM |