|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Exhaust spring
My exhaust spring is resting against the side of the pipe this is my 2nd pipe and fits a little different.
Was thinking wrap it in heat proof exhaust bandage or just stick some hose over it and see how it go's. Anyone else have the same problem what did you do?
__________________
06 EC250 |
#2
|
||||
|
||||
Mine touches on that side. I just let it touch.
|
#3
|
||||
|
||||
I think the last pipe was the same(touched) but was rattling so thought Id do some thing about it.
__________________
06 EC250 |
#4
|
|||
|
|||
Mines the same & the rattle got annoying so I put plastic hose pipe over it.
BUT - it eventualy melted, so I'm after something a bit more heat tollerant, silicon hose maybe...??? |
#5
|
||||
|
||||
I use electrical heat shrink cut to the length of the spring. Slide it over, mount the spring, shrink it with a heat gun. Doesn't prevent the spring from keeping tension, it's thin, won't melt.
__________________
Old GGs: 01 XC300, 02 XC125, 03 DE300, 03 DEO200, 01 SE300, 2011 EC300 Current: 05 DE250, Showa forked frankenbike 300, 05 DE300, 19 YZ250X |
#6
|
||||
|
||||
Might give it a go thanks
__________________
06 EC250 |
#7
|
||||
|
||||
Quote:
__________________
06 EC250 |
#8
|
||||
|
||||
Can you take off the exhaust flange and attach the spring from the inside out so the body of the spring is further away from the pipe?
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
High pitch Squealing from exhaust and exhaust flange????? | Scar13 | Enduro Engine - 2 stroke | 5 | 02-11-2012 11:32 AM |
Which Exhaust? | Pepperami | Enduro Engine - 2 stroke | 7 | 11-13-2011 09:15 PM |
FMF exhaust | gevandam | Enduro Engine 4 stroke (including EFI & Exhaust) | 0 | 04-28-2009 02:48 PM |
09 125 Exhaust? | hasslbri | Enduro Engine - 2 stroke | 2 | 01-28-2009 11:59 AM |
EC 300 Exhaust dB | jyellard | Enduro Engine - 2 stroke | 7 | 09-18-2008 08:30 AM |