|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
08-29-2018, 11:04 AM
|
|||
|
|||
Jetting alternative wanted
On my 300/2018 I run the JD Kit in the 38 Keihin.
I have the feeling, that it is a little bit lean in the second half while its fine from zero to 1/4 throttle, but after that its a bit too lean in my opinion. Currently I run: MJ178, Clip 3, red JD needle, PJ42, AS 1.75 turns open. Temperature 82F, Altitude 600 ft Is there a known alternative to the standard N1EF needle? Its good once the throttle is at 1/4, but down low I dont like it. Any hints/tricks appreciated. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| alternative to stock bars on '06 EC300? | brider | General Discussions & Announcements | 3 | 08-02-2014 09:03 AM |
| Alternative starter / light switches? | SingleTrackMind | Enduro Electrical & Wiring | 3 | 05-07-2014 05:19 PM |
| Alternative lighting for the 2012? | myrcrocks | Enduro Electrical & Wiring | 11 | 10-18-2012 08:40 PM |
| Float Bowl Gasket - Alternative | Harry | Enduro Intake/Carburetion - 2 stroke | 4 | 02-08-2012 01:26 AM |
| Noz. alternative of N1EG | BIS | Enduro Intake/Carburetion - 2 stroke | 3 | 07-13-2009 05:25 AM |
Threaded Mode