|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
First top end rebuild on 07 300..
Here's some pics and info, I would appreciate any comments or advice or if anyone spots something my untrained eye missed. . first of all I found two base gaskets I will be replacing with one what will the results be??
some pics of the old piston I think the new was overdue? ? the cylinder looked good I could still see the crooshaching from the old hone.. I measured the ring gap at a couple of points down the cylinder with the new piston ring. . maximum ring gap was 0.20 the top of the cylinder ring gap was 0.15... image of the head the carbon staining look odd all on the exhaust port side |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rebuild | bkwdc | General Discussions & Announcements | 5 | 08-01-2014 10:53 PM |
Can I do a rebuild myself? | stix49 | Enduro Suspension | 5 | 09-06-2012 12:39 PM |
Top end rebuild... | Woll | Enduro Engine - 2 stroke | 11 | 08-22-2011 07:24 PM |
Need help on top end rebuild | rpduc | Enduro Engine - 2 stroke | 17 | 03-26-2009 11:05 PM |
05 rebuild | brains | Enduro Suspension | 2 | 07-22-2008 08:54 AM |