|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Rubber Intake Manifold EC300
Hi all, I've purchased a new rubber intake manifold for my 2003 EC300 and was just wondering if it made any differance which end went on, i.e. is there a specific end for the carb and one for the engine side or does it make any differance??
|
#2
|
|||
|
|||
Mine has little arrows on it. But if the ID is the same it shouldn't make a difference.
|
#3
|
|||
|
|||
Apparently the older ones had the arrows on the and the newer OEM replacement parts don't and go on either way...
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Intake Noise | farmerj | Enduro Engine - 2 stroke | 10 | 11-21-2011 11:12 PM |
Rubber straps | Rabbitist | Enduro Chassis & Body | 4 | 06-01-2011 05:10 AM |
Intake rubber | spanner | Enduro Intake/Carburetion - 2 stroke | 4 | 12-23-2010 12:07 PM |
300 ec Intake rubber | Luke12379 | Enduro Intake/Carburetion - 2 stroke | 0 | 03-27-2010 09:34 PM |